Trio-75 Build Guide

在我们开始前,你得知道这些: Before we start, we need to pay attention to these things:
1.请使用附赠的螺丝刀,以免刮坏外壳
2.请不要使用乙醇擦拭涂层版本的外壳,这可能导致涂层的溶解或损坏
3.请避免用手直接接触PCB上的电子元器件,以免静电损坏pcb
4.Gakse贴纸不能反复粘贴,请再粘贴时仔细对准位置
1. Please use the included screwdriver to avoid scratching the case
2. Please do not use ethanol to wipe the the coated case, which may cause the dissolution or damage of the coating
3. Please avoid touching the electronic components on the PCB directly with your hands to prevent static electricity from damaging the PCB
4. Gakse stickers cannot be pasted repeatedly, please carefully align the position when pasting

Confirm these is in your Package

Start!

将脚贴粘贴在底壳对应位置 硅胶脚贴在您的配件袋内 。
Please check if any screws are missing, if everything is normal then. Place the included poron gasket on the bottom of the lower cover, and align the holes. 

翻转底壳,将配重、pcb子板与底壳连接
Put poron stickers on these positions and when you are done, your keyboard should look like this.

剪掉pcb poron的接缝,注意不要伤到自己,剪掉的部分请不要丢弃! 我们需要将其安装在空格键附近。
Cut off the seam of the pcb poron, be careful not to hurt yourself, please don’t discard the cut part!We need to install it near the space bar.

在箭头指示处拧上螺丝,将上盖固定
Tighten the screws at the place indicated by the arrow to fix the upper cover

Start!

将脚贴粘贴在底壳对应位置 硅胶脚贴在您的配件袋内 。
Please check if any screws are missing, if everything is normal then. Place the included poron gasket on the bottom of the lower cover, and align the holes. 

翻转底壳,将配重、pcb子板与底壳连接
Put poron stickers on these positions and when you are done, your keyboard should look like this.

剪掉pcb poron的接缝,注意不要伤到自己,剪掉的部分请不要丢弃! 我们需要将其安装在空格键附近。
Cut off the seam of the pcb poron, be careful not to hurt yourself, please don’t discard the cut part!We need to install it near the space bar.

在箭头指示处拧上螺丝,将上盖固定
Tighten the screws at the place indicated by the arrow to fix the upper cover

在箭头指示处拧上螺丝,将上盖固定
Tighten the screws at the place indicated by the arrow to fix the upper cover

在箭头指示处拧上螺丝,将上盖固定
Tighten the screws at the place indicated by the arrow to fix the upper cover

在箭头指示处拧上螺丝,将上盖固定
Tighten the screws at the place indicated by the arrow to fix the upper cover

在箭头指示处拧上螺丝,将上盖固定
Tighten the screws at the place indicated by the arrow to fix the upper cover

×
Welcome Newcomer